Arma 3: Sensors

Overview

Vehicle and ammo sensors for target detection and tracking.

Forum topic: Main thread

User Interface

Configuration

The new Sensor system gets enabled by defining a SensorsManagerComponent class inside the vehicle's Components class.

class MyVehicle_F : MyBaseVehicle_F
{
       class Components : Components                   
      {
            class SensorsManagerComponent : SensorTemplatePassiveRadar
            {
            };                                                                                            
      };
};

For simplicity the class can inherit from one of the templates that are available in the configFile root, which allows you to only change the properties you need.

class SensorTemplatePassiveRadar;  
class SensorTemplateActiveRadar;   
class SensorTemplateIR;            
class SensorTemplateVisual;        
class SensorTemplateMan;           
class SensorTemplateLaser;         
class SensorTemplateNV;

Properties

componentType

Mandatory property that defines the type/spectrum and hardcoded behavior of the sensor. Can be one of the following

• IRSensorComponent - detects irTargets according to their irTargetSize and their actual heat signature. Sources of heat are engine, tires or the muzzle. To become a detectable target in IR the engine has to be running at least 6 seconds. To become undetectable the vehicle may need to cool down even as long as 1 hour.
• NVSensorComponent - detects nvTargets.
• LaserSensorComponent - detects laserTargets.
• ActiveRadarSensorComponent - detects radarTargets according to their radarTargetSize. Radar needs to be switched ON via an action (Default Arma 3 and Arma 3 Apex keybind is (Ctrl+R)). Switching the radar on also makes the owner a detectable target for vehicles or ammo with passive radar component (see below). It's also the only sensor that can provide additional information about the target - its distance, speed and altitude.
• PassiveRadarSensorComponent - detects vehicles with active radar switched on at twice their active radar's range.
• VisualSensorComponent - detects visualTargets according to their visualTargetSize.
• ManSensorComponent - detects targets that inherit from Man class.

componentType = "ActiveRadarSensorComponent";

class AirTarget

Defines the sensor detection range in look-up conditions, when the target is positioned against a sky background. It's possible to cap the range by viewDistance (or its portion) for systems that work within visual range. Set the DistanceLimitCoefs to -1 to disable any impact of view distance on the sensor for beyond visual range systems.

class AirTarget      // ranges for targets with sky background
{                                            
        minRange = 50;         //blind range in meters     
        maxRange = 5000;       //maximum detection range in meters                  
                                                     
        objectDistaceLimitCoef = -1;    //limits the range by obj. view distance
        viewDistaceLimitCoef = -1;      //limits the range by view distance           
};

class GroundTarget

Defines the sensor detection range in look-down conditions, when the target is positioned against ground clutter. Properties are the same as in airTarget.

class GroundTarget      // ranges for targets with ground background
{                                            
        minRange = 50;         //blind range in meters     
        maxRange = 3000;       //maximum detection range in meters                  
                                                     
        objectDistaceLimitCoef = -1;    //limits the range by obj. view distance
        viewDistaceLimitCoef = -1;      //limits the range by view distance           
};

angleRangeHorizontal

Sensor horizontal (azimuth) coverage (in degrees)

angleRangeHorizontal = 120;

angleRangeVertical

Sensor vertical (elevation) coverage (in degrees)

angleRangeVertical = 120;

groundNoiseDistanceCoef

Portion of sensor->target->ground distance. Below this number the targets become invisible to the sensor even if they are still within the GroundTarget range.

 groundNoiseDistanceCoef = 0.1;  // If distance between vehicle and ground in the direction of the target is 1km then the target won't be detected as long as it stays less than 100m close to the ground background

maxGroundNoiseDistance

Distance from the ground background in meters, hard cap, above which the target will be visible even if still below groundNoiseDistanceCoef.

maxGroundNoiseDistance = 50; // In the situation from prev. example the target now becomes detectable whenever it is more than 50m from the ground background and still within the sensor GroundTarget range.

minSpeedThreshold

Target speed in km/h above which the target will start to become visible even if below groundNoiseDistanceCoef.

minSpeedThreshold = 100; // Following the prev. example if target is 20m from the ground background but it's moving more than 100km/h it may still be detected by the sensor.

maxSpeedThreshold

target speed above which the target becomes visible even if below groundNoiseDistanceCoef, linearly decreases to minSpeedThreshold.

maxSpeedThreshold = 1000; // Following the prev. example if target is 20m from the ground background but it's moving more than 1000km/h it will be detected by the sensor.

minTrackableSpeed

Minimum speed of the target that can be detected.

minTrackableSpeed = -1e10; // no minimum speed
minTrackableSpeed = 100; // targets slower than 100km/h won't be detected at all

maxTrackableSpeed

Maximum speed of the target that can be detected.

maxTrackableSpeed = 1e10; // no maximum speed
maxTrackableSpeed = 200; //targets faster than 200km/h won't be detected at all

minTrackableATL

Minimum altitude above terrain level that can be detected.

minTrackableATL= -1e10; // no minimum altitude
minTrackableATL= 50; // targets flying lower than 50m above ground and ground vehicles (unless jumping or dropped from an airplane) won't be detected at all

maxTrackableATL

Maximum altitude above terrain level that can be detected.

maxTrackableATL= 1e10; // no maximum altitude
maxTrackableATL= 1; // targets higher than 1m above won't be detected

animDirection

Model selection to set the sensor direction.

animDirection = "mainTurret";  // sensor will be aligned with the turret and will rotate together with it
animDirection = "";   // sensor will be aligned with vehicle body

aimDown

Elevation offset in degrees of the sensor from the animDirection.

aimDown = 35; // sensor will be looking 35° downwards from its original direction given by the animDirection

Example Config - full definition

class cfgAmmo
{	
        class MissileCore;
        class MissileBase: MissileCore
	{
		class Components;
	};	
        class My_Missile_Base: MissileBase
	{
		...
		missileLockMaxDistance 	= 3500; 
		missileLockMinDistance 	= 100;
		missileLockMaxSpeed 	= 2450;
		missileLockCone		= 50;
		// The properties above limit the locking range, cone and conditions but they are are independent from the sensor. The don't say what the missile can see and track. In this case they are set to similar values as sensor, so what the missile seeker can see and track the missile will also be able to lock onto.
		...

		class Components: Components
		{
                        class SomeRadarSensorComponent                   
                        {                                                 
                                componentType = "ActiveRadarSensorComponent";
                                class AirTarget      // ranges for targets with sky background
                                {                                            
                                    minRange = 50;         //blind range in meters     
                                    maxRange = 5000;       //maximum detection range in meters                  
                                    objectDistaceLimitCoef = -1;    //limits the range by obj. view distance
                                    viewDistaceLimitCoef = -1;      //limits the range by view distance           
                                };                                                                                    
                                class GroundTarget      // ranges for targets with ground background                           
                                {                                            
                                    minRange = 50;                
                                    maxRange = 3000;                 
                                    objectDistaceLimitCoef = -1;               
                                    viewDistaceLimitCoef = -1;                 
                                };                                                                                           
                                angleRangeHorizontal = 60;     // sensor azimuth coverage in degrees         
                                angleRangeVertical = 60;       // sensor elevation coverage in degrees       
                                groundNoiseDistanceCoef = 0.5;  // portion of sensor-target-ground distance below which the targets become invisible to the sensor
                                maxGroundNoiseDistance = 250;   // distance from the ground in meters, hard cap, above which the target will be visible even if still below groundNoiseDistanceCoef
                                minSpeedThreshold = 110;        // target speed in km/h above which the target will start to become visible           
                                maxSpeedThreshold = 130;       // target speed above which the target becomes visible even if below groundNoiseDistanceCoef, linearly decreases to minSpeedThreshold     
                                minTrackableSpeed = -1e10;     // min speed that can be detected
                                maxTrackableSpeed = 1e10;      // max speed that can be detected
                                minTrackableATL = -1e10;       // min altitude above terrain level that can be detected
                                maxTrackableATL = 1e10;        // max altitude above terrain level that can be detected     
                                animDirection = "";   // model selection to set the sensor direction                        
                                aimDown = 0;                    // elevation offset in degrees of the sensor from the animDirection              
                        };
		};
	};
};

Example Config - inheritance from template

class SensorTemplateActiveRadar;   
class SensorTemplateIR;

class cfgVehicles
{	
        class Plane;
        class Plane_Base_F: Plane
	{
		class Components;
	};	
        class My_Plane_Base: Plane_Base_F
	{
		class Components: Components
		{
			class SensorsManagerComponent
			{
			        class ActiveRadarSensorComponent : SensorTemplateActiveRadar
			        {
					class AirTarget      
					{                                            
						minRange = 60; 
						maxRange = 6000;                                              
						objectDistaceLimitCoef = -1; 
						viewDistaceLimitCoef = -1;             
					};                                                                                                                        
					angleRangeHorizontal = 60;            
					angleRangeVertical = 60;      
				};
			        class IRSensorComponent : SensorTemplateIR { };
			};
		};
	};
};

Related

• CfgAmmo
• CfgVehicles
• Arma 3 Custom Info
• Arma 3 Components
• Arma 3 Targeting
• Sensor Overhaul thread