setObjectScale

2.02

LALocalGEGlobal

Hover & click on the images for description

Description

Description:

Scales an attached object or a Simple Object's model.

Problems:

The Arma 3 LOD limits still apply, meaning walk-able surfaces can only be X m in size, and collision in general will only work up to X m from object center. This command works on all objects in Eden Editor or scenario preview, but it will not save and will reset when objects get moved. Eden Editor support is only intended for artists.

ⓘ

Setting the scale of non-simple objects, such as vehicles with players/AI in them, static objects (simulation = "house" in config), etc. might be possible, but not officially supported. You may encounter issues.

⚠

Changing the direction of the object (e.g. using setDir, setVectorDir, etc.) will reset the object back to its original size (probably because the engine normalizes the directions, thus the scale in the transformation matrix becomes 1), so those commands should be run before resizing the object.

Groups:

Object Manipulation

Syntax

Syntax:

object setObjectScale scale

Parameters:

object: Object - Must be either an attached object or Simple Object

scale: Number - Limited to 0.0001 to 65504, relative to the object model's normal scale

Return Value:

Nothing

Examples

Example 1:

_mrap attachTo [player,[0,0,0]]; _mrap setObjectScale 0.1;

Example 2:

// Select an object in Eden Editor and execute the following code in the Arma 3: Debug Console. When moving the object, the effect is reset! (get3DENSelected "Object" # 0) setObjectScale 0.1;

Additional Information

See also:

getObjectScale

Notes

Report bugs on the Feedback Tracker and/or discuss them on the Arma Discord or on the Forums.
Only post proven facts here! Add Note

Waffle SS. - c

Posted on Dec 23, 2021 - 06:29 (UTC)

For those interested in the extra cursed, you can scale non-simple objects by running the command every frame. The multiplayer performance of this is likely terrible.

addMissionEventHandler ["EachFrame", { { if (_x != player) then { _x setObjectScale 0.5; }; } forEach allUnits; }];

P1ker1 - c

Posted on Jan 04, 2022 - 22:17 (UTC)

Note that

_obj setObjectScale 2;

doubles the scale factor of an object, not the volume. In the case of a cube this would be the length of an edge.
If you want to multiply the volume, raise the scale to the power of 1/3.

// Example with 1x1x1 m^3 helper objects // vectorAdds elevate the cubes so they touch the ground after scaling. _cube1 = createSimpleObject ["Land_VR_Shape_01_cube_1m_F",(getPosASL player vectorAdd [1,3,0.5])]; _cube2 = createSimpleObject ["Land_VR_Shape_01_cube_1m_F",(getPosASL player vectorAdd [3,1,0.5])]; _cube3 = createSimpleObject ["Land_VR_Shape_01_cube_1m_F",(getPosASL player vectorAdd [1.35,1.35,0.13])]; // Double the side length. V=2^3=8 _cube1 setObjectScale 2; // Octuple(8x) the volume. V=(8^(1/3))^3=8 _cube2 setObjectScale 8^(1/3); // Double the volume. V=(2^(1/3))^3=2 _cube3 setObjectScale 2^(1/3);